user_mobilelogo

Search the Blog

patreon logoLike what you read? Find the posts helpful? Support the blog via Patreon to get even more of the stuff you enjoyed!

Tablet weaving Shenanigans, Part 2 – or: Don’t forget the weft.

When I started out trying to reconstruct how twill may have been tablet woven back in the Middle Ages, I had a list of things that the method would need to deliver – if you like being fancy, you could say I had a Requirement Specification. Apart from the obvious (has to work without written patterns, has to work with an indefinite number of tablets), one of my list items was “has to be robust” as in the system should be so workable that it is possible to stop at any time and take up the work again without a problem, and that it should be possible to weave while other stuff is going on in the vicinity, or while you’re not one hundred percent fit. Also obviously, weaving really complex patterns in fine silk on a wide band won’t work if you are bone tired and there is a bunch of people nattering at you – but to do simpler twill motifs, it should not matter if there is a group of others chatting in the same room, and you are keeping half an ear on it, occasionally joining into the chat.

Both the coffee cup weaving and the UFO weaving took place while there was a pen-and-paper roleplaying session going on in the same room, which for me sort of qualifies as “mildly distractive environment”. So for my expectations, the system is robust enough; it does happen occasionally that I forget to re-order a few tablets, but I usually catch this even before turning them, and if I don’t, it becomes really obvious right afterwards, and is easy to fix. (Turn the offenders back, sort, re-turn them.)

Something that happens even more occasionally, but that is much, much more of a nuisance: Forgetting a weft thread. This has really obnoxious results. First of all, it only becomes rather obvious a good while after the vile deed has happened, and I’m usually not willing to unweave two picks to fix the issue. Unfixed, the forgetting of a weft results in long floats across the width of the band, which can be very obvious if you are looking at the structure (or are a nitpicky person and are looking for mistakes). It actually happened twice when I was doing the UFO, see if you can find the spots:

Have you found them?

The second effect of forgetting a weft, which is at least as annoying, is that I use the side the shuttle hangs on as an indicator of what may or may not be done at that stage, pattern-wise. So having forgotten a weft, this changes, which can be confusing, even when using a marker on one side of the band to keep track of the “do-things-side” as opposed to the “maintenance-mode-side”.

I complained about this to the Most Patient Husband Of Them All, and he quite correctly said that there must be a way to see that the weft thread is missing… so we spent a while discussing all the possible ways we could, collectively, think of.

The end result was that since the missing weft causes a change in the band structure, it is possible to see it right after you turn the tablets and press in the shed. However, since every thread is only tied down by the weft every fourth pass, this means only every fourth tablet shows this structural difference – so it is visible, but it is very subtle.

Here is how it looks with the weft thread in:

And this is the same pick without the weft thread:

It’s no wonder I never noticed before when I had missed putting in a weft (and none of my students did when this happened in a workshop). Now that I know what to look for, though, I’ll keep an eye open for the telltale tiny gaps on the edge of the weaving knife when pressing in.

Are you occasionally forgetting the weft? Do you go back when that happens to you?

This entry was posted in all the gory details, tablet weaving. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *